Home > Motors & Gearings > Motor / Gearing Tuned Systems > Kid Trax 2021 Bronco, Dodge Ram & Charger >

Stage I Kid Trax Motors
Stage I Kid Trax Motors


 
: $85.00
: $68.00
Savings: $17.00

Product Code: STAGE-I-KID-TRAX-MOTORS


Installation Aids:

Heat Sink Option



Qty:  
Description
 
This is a matched pair of 550 High Performance motors for Kid Trax Dodge Ram Pickups, Chargers, and Land Rover Defenders. Also works with Kid Trax Firetrucks that have a 19T pinion on the stock motor. Just unbolt your old motor and bolt in the new one. These motors will add significant speed over stock motors. With each pair you get:
* Torque Sleeves around each motor to add more low-end power.
* Built-in Cooling Fans.
* Spade Connectors for quick wire installation. Makes motors/gearboxes easy to take in and out of vehicle.
* Lightweight metal pinion gears installed on the motors with threadlock.
* Bendable motor wire tabs so as not to break as easy as stock ones.

Motors are warrantied for up to 12 volts of SLA batteries and are often used with 18 volts of SLA batteries (not warrantied). It is HIGHLY RECOMMENDED to add the 550 Cooling Fan Kit if you do run 18 volts. Still helpful for 12 volt vehicles too. We strongly recommend using our Metal First Gears when running 18 volts or more.

Just like when modifying a real car, modifying a Power Wheels voids all warranties. If you have made any non-MLToys modifications to your car you should reach out to our tech support first to check compatibility. MLToys bears no responsibility for damage to vehicle, persons, or property incurred by modifying a vehicle. Be Smart, Be Safe, and Have Fun!
Stage I Arctic Cat at 18 Volts
How to Install Kid Trax Motors and Gears
How and Why to Break-in Motors
How to Properly Apply Grease

Recommended Accessories
Four Point Safety Harness Axle Thrust Bearing 550 Cooling Fan Kit Dual Motor Temperature Gauge In-Dash
: $19.99

Add
: $1.70

Add
: $28.00

Add
: $10.00

Add
Four Point Safety Harness Axle Thrust Bearing 550 Cooling Fan Kit Dual Motor Temperature Gauge In-Dash
Brake Reduction Module
: $11.00

Add
Brake Reduction Module

Average Rating: Average Rating: 4.5 of 5 4.5 of 5 Total Reviews: 15 Write a review »

  0 of 0 people found the following review helpful:
 
4 of 5 Brake September 13, 2021
Reviewer: Chip Brandt from China Grove, NC United States  
Have not installed it yet

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Good motors July 4, 2021
Reviewer: Jeremy Nungesser from Azle, TX United States  
Replaced stock motors was an easy swap

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Good September 12, 2020
Reviewer: Lloyd Smyly from Walterboro, SC United States  
Good

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 12 volt motor upgrade August 3, 2020
Reviewer: Fernando Gonzalez from Indio, CA United States  
Online instructions easy to follow. The 10 to 15% speed increase is accurate.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
1 of 5 Lasted for an hour July 8, 2020
Reviewer: Wesley Wade from Cynthiana, KY United States  
Installed these motors on our ram truck, motors ran great for an hour and then quit working.

Was this review helpful to you?

View All Customer Reviews